[. . . ] WASHING MACHINE Parts supplied INSTALLATION GUIDE Tools needed Water supply hoses Hose guide Tie strap (option) Tape measure carpenter’s level Pilers Flat screwdrilver 5 French on back  Spanish on back  CONNECTING THE DRAIN HOSE. [. . . ] Remove all shipping bolts at the back of washer with supplied spanner. Hold the shipping bolt Fill the holes with the with your hand and pull it supplied bolt hole covers. Use a carpenter’s level on all four corners of your washer to ensure it’s level. Rubber washer Coupling Rubber washer Level the washer by turning the leveling wheel in or out as required by using the supplied wrench. When your washer is leveled, tighten the locking nuts using the wrench or (-) flathead screwdriver. Run a test cycle(Rinse+Spin) with small amount of laundry such as 4~5 Towels. C  If water leaks while water is being supplied or drained, check the water connections. (Refer to Step 3, 4, 5)  If the washer rocks and vibrates excessively, level your washer again. [. . . ] INSTALLATION COMPLETION CHECKLIST □ Washer plugged in, power OK □ No water leakage □ No vibration / noise □ Water hose connected properly □ Washer leveled □ Drain hose connected properly □ Shipping bolts removed DC68-02580C-04  CAUTION: Make sure that the HOT & COLD hoses are switched with each other. [. . . ]